(pts 1-4) There are two categories of stropping, stropping on a clean substrate, and stropping on a substrate with compound. Stropping is done to reduce the width of the edge, and to help remove and align any burrs along the edge. # Clean Stropping Stropping on a clean substrate achieves 4 things: 1. It realigns the edge 2. It burnishes the metal (moves it without destroying it), making the edge smoother 3. Abrasion - It makes scratches less defined and smooths out the blade 4. Removes coating - Some blades come with a manufacturer applied oil, you can use a strop to remove this coating # Loaded Stropping With a loaded strop, abrasive compound is applied to the strop to increase the rate of abrasion. This compound is applied with the goal of reducing the width of the edge without the formation of a foil-edge burr. Loaded stropping tends to produce a micro-convex edge, meaning it's shaped a little bit like a teardrop, where it curves outwards from a straight angle the farther away from the vertex the edge goes. This effect is generally desirable. The effect of stropping happens quickly, within 3-30 laps, and 10 laps being the minimum needed to achieve the desired effect. Stropping past 30 achieves minimal change, and stopping past the hundreds may introduce a burr again. It was generally noted that when stropping with a very fine compound (eg, 0.25 micron), a small but consistent burr would form. When stropping with a coarse compound, a larger burr would occur, but one that formed unevenly. To achieve the best of both worlds, it's suggested that you start stropping with a coarse material, then move to a fine material. > Successfully designed stropping progression should involve different strop materials rather than different sized abrasives on the same substrate. I can't find the exact source, but it seems that denim and a loaded leather strop with between 0.5-0.25 micron compound would be ideal. ## Strop Material There are a variety of stropping materials available for use, common materials include leather, denim, newspaper, washcloth, and balsa wood. ### Balsa Because balsa wood is rigid and nearly incompressible, stropping on balsa produces minimal convexity. Micro convexity is still achieved. ### Nanocloth Nanocloth is a soft, flexible material mounted on a hard, flat glass substrate. It's a synthetic polishing cloth sold by Ken Schwartz. It appears to achieve slightly more micro convexity than the balsa substrate. ## Latigo (Bovine) Leather ## Compound material ### Chromium Oxide Chromium Oxide (green, waxy substance) is probably the most common stropping compound. While it's moderately effective, there are better options, and it's generally recommended that if you strop a blade on a chromium oxide loaded strop, you follow it up with fine abrasive or a clean leather strop. ## Mono-diamond Mono crystalline diamond stropping compound comes in a wide variety of grit sizes, ranging from 0.1 micron, all the way up past 20 micron. | Compound size | Result | | ------------- | ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ | | 0.25 micron | After 10 laps on a bovine leather strop, it did not sufficiently remove the bur. With 100 laps, it got closer, but a noticeable bur was still present. 0.25 micron appears to remove material very slowly, almost too slowly, but it produces a fine finish. | | 0.5 micron | After 10 laps on bovine leather, significantly more abrasion occurred than with the 0.25 micron compound. No significant change in edge geometry was noted compared to use of the 0.25 micron stropping compound. | | | | | 10 micron | When stropping with 10 micron compound, it was noted that the entire bevel began to convex, and significant removal rate occurred. Large burrs were left on parts of the edge, but further stropping on linen and clean leather would remove those burrs. |